All Questions
Tagged with openvswitch virtual-machines
6
questions
0
votes
1
answer
144
views
No layer 2 traffic in an Open vSwitch bridge
I see no traffic in layer 2 and above in an OVS bridge, but I do see layer 1 traffic.
I have the following setup:
I have created a Linux VirtualBox VM with three adapters: NAT with port forwarding the ...
2
votes
1
answer
1k
views
KVM Networking - assign IP to each VM by outside DHCP
I am new to KVM and am having a problem with setting up the networking. I want each VM to get its IPs assigned by the network's DHCP, not the internal DHCP that the KVM keeps trying to set up. In ...
-2
votes
1
answer
933
views
GRE tunneling using Open vSwitch
I am trying to implement tunneling as described here with the following setup (without any success):
ho1 is a host only interface. I want to connect Nested Guest 11 and Nested Guest 21.
I have read ...
3
votes
4
answers
654
views
Lab of virtual computers connected to virtual switch with port forwarding
I have a lab in which I have three computers connected to a switch.
two of the switch's ports are mirrored to a third port so that all the communication between the two computers is mirrored to the ...
0
votes
1
answer
307
views
how to direct all the traffic associated with a VM to a separate physical ethernet interface in Xen?
I have 3 VMs running on Xen hypervisor with Ubuntu 14 DomU.I want to configure my network in such a way that traffic to and from Vm1 goes out via eth1, vm2 via eth2 and so on.
For this i need to use ...
0
votes
1
answer
2k
views
./pox.py log.level --DEBUG forwarding.l2_learning not working as expected
I have installed openvswitch on my PC with runs Ubuntu 12.04.I also have virtual box running on my PC with 3 virtual machines (Ubuntu 12.04) running on them. are named
vm-1
vm-2
vm-3
I have ...